![]() If the compound appears to bubble or pool a bit in the hole, poke it with the point of the putty knife to release the trapped air. After cleaning the blade, hold the knife at a sharper angle (around 45 degrees) and drag it across the hole (left to right or right to left) to remove the excess compound. Holding the knife at a shallow angle above the hole, drag the knife down over the hole while pushing mud into the hole and indentation. Grab a bit of joint compound with the end of a clean putty knife and scrape away the excess mud on the back of the knife. A little goes a long way, so add it sparingly. Tip: If you’d like a faster-drying patching compound, you can mix additional powdered joint compound (also known as hot mud) or Plaster of Paris into the mix. Once mixed, scoop a bit of compound out onto the hawk or into the tray and clean off the putty knife. Just be sure to mix until any separated water incorporates with the mix. If you don’t have a paddle, you can mix it with a putty knife. If you have a paddle mixer, tighten it in your drill and mix the compound, being careful not to lift the spinning paddle above the bucket. ![]() Prepare the compoundįresh buckets of drywall compound often need a good mixing before they’re ready for use. Also, remove any loose drywall paper with the utility knife. You can scrape the blade of the putty knife over the screw hole to ensure it’s smooth and remove any flaked paint. For small holes, just tap the nail hole with a hammer to drive it below the drywall surface and create a small indentation.If the anchor doesn’t come out, simply tap it below the drywall surface. For large holes (½-inch or so), roll up drywall tape and fill the hole snuggly. For anchors, remove the anchor from the wall and tap the hole with a hammer so it’s slightly below the wall surface.Don’t overdrive the fastener-just below the surface is ideal. Use a hammer to drive the nail deeper or a screw gun to tighten the drywall screw. For installation nails and screw holes in drywall, be sure that the fastener’s head is below the drywall surface.You’ll need to determine whether the hole is from nails or screws driven during installation, an anchor used to hold up a heavy object, or simply a small hole from hanging a picture. There are some slight differences in technique when patching different holes, though the process remains mostly the same. Patching holes in your drywall is a fairly simple task that you can probably do yourself without calling a repair person. ![]() $75.00 USD | 1H 49M Preview Course How to patch screw or nail holes in drywall
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |